The sampling rate is the average ratio of the number of packets incoming on an sFlow-enabled port, to the number of flow samples taken from those packets.
You can change the default (global) sampling rate. You also can change the rate on an individual port, overriding the default sampling rate of 512. With a sampling rate of 512, on average, one in every 512 packets forwarded on an interface is sampled.
Reading Time: 2 minutes All Palo Alto Networks firewalls support NetFlow (Version 9) except the PA-4000 Series and PA-7000 Series firewalls. The firewalls support only unidirectional […]
Reading Time: < 1 minute NetFlow can be configured in Dashboard on the Network-wide > Configure > General page. NetFlow configuration settings are found under the Reporting header, with the […]
Reading Time: < 1 minute 1. The following commands configure a Force10 switch (10.0.0.245), sampling packets at 1-in-512, polling counters every 30 seconds and sending the sFlow to […]
Reading Time: < 1 minute 1 . Configure a destination : dell (config)# sflow 1 destination x.x.x.x dell (config)# sflow 1 destination owner <owner_name> timeout 4294967295 The above […]
