Enable sFlow on DELL

Reading Time: < 1 minute

1 . Configure a destination :

dell (config)# sflow 1 destination x.x.x.x
dell (config)# sflow 1 destination owner <owner_name> timeout 4294967295
Note The above commands will send sFlow to the destination IP « x.x.x.x » which is the one used by BLËSK.

 

2 . Enable sample rate and polling interval :

dell (config)# sflow 1 sampling ethernet 1/g1-1/g32 1024
dell (config)# sflow 1 polling ethernet 1/g1-1/g32 20
Note The above configure the sampling packets at 1-in-1024, and polling counters every 20 seconds.

wpadmin
Author: wpadmin

You may also like

Enable Netflow on Palo Alto

Enable Netflow on Palo Alto

Reading Time: 2 minutes All Palo Alto Networks firewalls support NetFlow (Version 9) except the PA-4000 Series and PA-7000 Series firewalls. The firewalls support only unidirectional […]

Enable sFlow on FortiGate

Enable sFlow on FortiGate

Reading Time: < 1 minute Recent FortiOS release adds sFlow support to Fortinet’s FortiGate® appliances. The following commands configure a FortiGate to sample packets at 1-in-10, poll […]

Enable sFlow on Force 10

Enable sFlow on Force 10

Reading Time: < 1 minute 1. The following commands configure a Force10 switch (10.0.0.245), sampling packets at 1-in-512, polling counters every 30 seconds and sending the sFlow to […]

Enable NetFlow on Cisco

Enable NetFlow on Cisco

Reading Time: 2 minutes To ensure that the necessary hardware is enabled, issue the show module command, as follows: show module all Mod Submodule Model Serial […]