Enable sFlow on HP

Reading Time: < 1 minutes

The commands bellow only works on the 3500/5400/8200/6200 HP products.

1. Configure a destination :

hp (config)# sflow 2 destination x.x.x.x 6343
Note The above commands will send sFlow to the destination IP « x.x.x.x » which is the one used by BLËSK.

2. Enable sample rate and polling interval :

hp (config)# sflow 2 sampling all 10
hp (config)# sflow 2 polling all 20

You can enable sample rate and polling interval depending of the accuracy of the received packet that you want to get. Use the « all » parameter in sampling and polling parameters to enable sFlow on all interfaces.

wpadmin
Author: wpadmin