Enable SNMP & Traps on HP

Reading Time: < 1 minutes

Use Telnet or SSH to connect to your switch, then enter the following commands to enable and configure SNMP.

configure
no snmpv3 only
snmp-server enable
snmp-server community 1qaz2wsx unrestricted
snmp-server contact support@domain.com
snmp-server location Brossard
snmp-server host x.x.x.x community 1qaz2wsx trap-level critical
exit
write mem
Note The above commands will set it to allow any IP to make SNMP requests on the switch. The « 1qaz2wsx» represent the community string and « x.x.x.x » the IP address of the remote Monitoring Server used to send Traps.

wpadmin
Author: wpadmin