Enable System Logs on DELL

Reading Time: < 1 minute

Use Telnet or SSH to connect to your switch, then enter the following commands to enable and configure system log messages to be exported to your BLËSK server.

configure
logging on
logging <ip or hostname of monitoring server>
exit
copy running-config startup-config
Note The above commands will set it to log everything to the IP or host name of the BLËSK Server.

wpadmin
Author: wpadmin

You may also like

Enable System Logs on Brocade

Enable System Logs on Brocade

Reading Time: < 1 minute Use Telnet or SSH to connect to your switch, then enter the following commands to enable and configure system log messages to […]

Enable System Logs on Windows

Enable System Logs on Windows

Reading Time: < 1 minute Windows doesn’t come with a software to export system logs externaly. You have to find one from third party and install it […]

Enable System Logs on Avaya/Nortel

Enable System Logs on Avaya/Nortel

Reading Time: < 1 minute To configure syslog servers for the cluster, use the following command. /cfg/sys/syslog followed by: add x.x.x.x * x.x.x.x is the IP address […]

Introduction

Introduction

Reading Time: < 1 minute Revision 1.2.7 – (08-12-2016)   This document explains how to configure network devices such as Switches, Routers or Firewalls to send log […]