1. Enabling the sFlow, NetFlow, or jFlow protocol (if available) will allow a better view of traffic flow.
2. If it’s not possible to use one of these protocols, then you can configure port mirroring on your switch.
3. Another solution is to install bProbe. This method also requires a port mirroring configuration.
Reading Time: < 1 minute 1. NCM only needs to have access to your devices through SSH or Telnet, therefore ensure that the credentials for SSH […]
Reading Time: < 1 minute 1. Be sure that the SNMP protocol is enabled and configured on all of your network devices.
Reading Time: < 1 minute Revision 1.0.4 – (08-27-2018) When deploying a monitoring system, it is important to remember that 70% of the configuration is done […]
Reading Time: < 1 minute 1. Activate and configure system events on network devices such as Switches, Firewall, UPS, etc… 2. Install and configure an event […]
