Configuring System logs on Network devices

Notice: Undefined index: Open+Sans in /var/www/blesk/wp-content/plugins/documentor/core/includes/fonts.php on line 10 Notice: Undefined variable: ptfamily in /var/www/blesk/wp-content/plugins/documentor/core/guide.php on line 490 Notice: Undefined index: Open+Sans in /var/www/blesk/wp-content/plugins/documentor/core/includes/fonts.php on line 10 Notice: Undefined variable: ptfamily in /var/www/blesk/wp-content/plugins/documentor/core/guide.php on line 562 Notice: Undefined index: Open+Sans in /var/www/blesk/wp-content/plugins/documentor/core/includes/fonts.php on line 10 Notice: Undefined variable: ptfamily in /var/www/blesk/wp-content/plugins/documentor/core/guide.php on line 628
  1. Introduction
  2. Enable System Logs on Cisco
  3. Enable System Logs on PIX/ASA 55xx
  4. Enable System Logs on Brocade
  5. Enable System Logs on DELL
  6. Enable System Logs on HP
  7. Enable System Logs on FortiGate
  8. Enable System Logs on Windows
  9. Enable System Logs on Avaya/Nortel

Enable System Logs on Cisco

Use Telnet or SSH to connect to your Switch/Router, then enter the following commands to enable and configure system log messages to be exported to your BLËSK server.

conf t
no service sequence-numbers
no service timestamps debug uptime
no service timestamps log uptime
logging trap warnings
logging x.x.x.x
exit
write mem
Note The above commands will set it to log everything to the IP or host name of the BLËSK Server.
« IntroductionEnable System Logs on PIX/ASA 55xx »
Suggest Edit